Beijer Electronics Industrial Inverter E2 - Manual (Page 4)

4
Mechanical Mounting
- Information can be found
on page 10
Keypad operation can be
found on page 17
Motor Cable Sizes
- Check the rating
information on page 28
- For EMC compliance, use
a shielded type cable
-
Motor Connections
- Check for Star or Delta connection
according to the motor voltage rating
(See page 13)
Motor Nameplate Details
- Enter the motor rated voltage in P-07
- Enter the motor rated current in P-08
- Enter the motor rated frequency in P-09
Fuses
or MCB
Earth L N
L1 L2 L3
AC Supply Voltage
(50 / 60Hz) Supply Voltage :
- 110-115, 200-240, 400-
480 +/- 10%
- 1 or 3 Phase
- Check the drive rating
information on page 28
Fuses or MCB, Cable Sizes :
- Fuse Ratings given on page
28
- Recommended cable sizes
shown on page 28
Always follow local and national
codes of practice
IP66 Easy Start-Up Guide
(Un-switched Variant)
RJ45
Connector
Control Terminals
Based on the factory default (out of box)
settings
- Connect a Start / Stop switch
between terminals 1 & 2
- Close the switch to Start (Enable)
the drive
- Open the switch to Stop (Disable)
the drive
- Connect a potentiometer (5kΩ
minimum) between terminals 5, 6
and 7 as shown below to vary the
speed from minimum (0Hz) to
maximum (50 / 60 Hz)