Beijer Electronics Industrial Inverter E2 - Manual (Page 3)

3
Motor Cable Sizes
- Check the rating
information on page 28
- For EMC compliance, use
a shielded type cable
Keypad operation can be
found on page 17
Fuses
or MCB
Earth L N
L1 L2 L3
AC Supply Voltage
(50 / 60Hz)
Motor Connections
- Check for Star or Delta connection
according to the motor voltage rating
(See page 13 )
Motor Nameplate Details
- Enter the motor rated voltage in P-07
- Enter the motor rated current in P-08
- Enter the motor rated frequency in P-09
Supply Voltage :
- 110-115, 200-240, 400-
480 +/- 10%
- 1 or 3 Phase
- Check the drive rating
information on page 28
Fuses or MCB, Cable Sizes :
- Check the drive rating
information on page 28
- Recommended cable
sizes shown on page 28
Always follow local and
national codes of practice
Local Speed Potentiometer
The local speed potentiometer will adjust
the output frequency from minimum
(Parameter P-02, default setting = 0Hz) to
maximum (Parameter P-01, default
setting = 50 / 60Hz)
Run Reverse / Off / Run Forward Switch
With the factory parameter settings, this
switch allows the drive to be started in
the forward and reverse operating
directions. Alternative switch functions
can be programmed, such as Local /
Remote, Hand / Off / Auto, see page 15
Local Power Isolator
with lock off
provision
Mechanical Mounting
- Information can be found
on page 10
IP66 Easy Start-Up Guide
(Main switch and Hand-control Variant)
RJ45
Connector