Beijer Electronics M70 EN - Manual (Page 13)

Connection
Beijer Electronics, MAEN843A 13
4.2.2 RS232C Cable Outlet
The drawing below illustrates the cable outlet when the RS232C interface is
used.
4.3 Ethernet Connection
The M70 is equipped with an Ethernet interface based on the 10 Base T speci-
fication and suitable for half-duplex mode.
The Ethernet connector S4 (marked ETHERNET) in the cable entrance area of
the M70 is used.
The following interface parameters are defined and cannot be changed:
– 10 Mbit/s
– TCP/IP protocol
If the M70 and the control do not communicate via a point-to-point connec-
tion, it may happen that the keypad data, for example, are transmitted with a
delay. To avoid this, it is advisable to establish the connection via an Ethernet
switch which enables a point-to-point connection.
The positions of the dip switches in the cable entrance area are not relevant for
this interface.
Note:
The Ethernet connection cannot be used simultaneously with an RS232C connection.
B5
CAS-220 TB1
Serien-Art.-Nr. Etikett
1 S12
S10
S4
S1
1
S2 0
B4
H1
B3 B2
S28
CAS-220 TB1
B 1
1
Serien-Art.-Nr. Etikett
S12
S10
S4
S1
1
S2 0
B4
H1
B3 B5 B2
S28
CAS-220 TB1
B 1
CAS-220 TB1
right left