Panasonic DMC-GH4KBODY - Manual (Page 187)

187
7. Flash
Taking Pictures with Wireless Flashes
By using flashes that support the wireless control (DMW-FL360L, DMW-FL580L: optional),
you can control firing of the built-in flash (or a flash attached to the hot shoe of this unit)
and three flash groups separately.
1
Set the wireless flashes to RC Mode and then place them.
• Set a channel and groups for the wireless flash.
2
Press the flash button to open the built-in flash or attach a flash
(DMW-FL360L or DMW-FL580L: optional) to the camera.
3
Select the menu. (P54)
4
Press 3/4 to select [ON] and then press [MENU/SET].
• When [Wireless] is set to [ON], [WL] is displayed on the flash icon on the recording
screen.
Applicable modes:
∫ Placing wireless flashes
Place the wireless flash with its wireless sensor facing toward the camera.
The following figure shows the estimated controllable range when you take pictures by
holding the camera horizontally. Controllable range differs depending on the surrounding
environment.
Placement example
• In this placement example, flash C is placed to erase the shadow of the subject that flashes A
and B will create.
• The recommended number of wireless flashes for each group is three or less.
• If the subject is too close, signal flashing may affect the exposure.
If you set [Communication Light] to [LOW] or lower the output with a diffuser or similar product,
the effect will be reduced.
> [Rec] > [Flash] > [Wireless]
5m
5m
7m
7m
50 ° 50 °
50 ° 50 °
30 ° 30 °
30 ° 30 °
(23 feet)
(23 feet)
(16 feet)
(16 feet)
A
B
C
MENU