Avocent SwitchView - Manual (Page 17)

Chapter 2: Installation
11 10
SwitchView IP Installer/User Guide Chapter 2: Installation
11
To configure mouse acceleration on NetWare 6 servers running Java 1.4.1:
1. From the NetWare 6 Graphical User Interface (GUI) Environment tool
Input tab, select Turn off mouse acceleration.
2. Click Apply and restart the GUI.
To configure mouse acceleration on NetWare 6 servers running Java
1.3.1 CSP8 or CSP9:
1. Add the following command to the NetWare 6 sys:/java/nwgfx/xinitrc file:
xset m 1
2. Save the file and restart the GUI.
To configure mouse acceleration on Linux:
Execute the following command line parameter:
xset 0 255
-or-
xset m 0
NOTE: If the host computer is running an operating system that does not support turning off
mouse acceleration, you will need to set the SwitchView IP Viewer Auto Mouse Sync to Off. For
more information on the Auto Mouse Sync feature, see Chapter 3.
Video settings
The following table lists the video resolutions and refresh rates supported by
the SwitchView IP on the host computer.
Video Resolutions and Refresh Rates
Resolutions Refresh Rates Resolutions Refresh Rates
512 x 384 70 Hz 720 x 400 60, 70, 75, 85,
100 Hz*
640 x 480 60, 67, 72, 75, 85, 90, 800 x 600 56, 60, 72, 75, 85, 90,
100*, 120*, 140* Hz 100*, 120*, 140* Hz
832 x 624 75 Hz 960 x 720 60, 75, 85 Hz
1024 x 768 60, 70, 75, 80, 85, 1024 x 800 60 Hz
90*, 100* Hz
1152 x 864 60, 70, 75, 76, 80, 1152 x 870 75 Hz
85* Hz
1152 x 900 67 Hz 1280 x 960 60, 75*, 85* Hz
1280 x 1024 60, 67*, 75*, 85* Hz
NOTE: *These refresh rates may not provide the best video lock on all video cards. For best
performance, use the lowest refresh rate for any of the resolutions listed.