Sony DSC-W1 - Manual (Page 107)

model name1[DSC-W1/W12]
[3-091-535-11(1)]
filename[Z:\#Camera#\DSCW1\3091535111DSCW1U2\14trb.fm]
masterpage:Right
107
T
ro
uble
s
hoo
ti
n
g
• The battery level is low or zero. Charge the batteries (page 11). Depending on the conditions of use or the type of
batteries, the indicator may flash even though there are still 5 to 10 minutes of remaining battery time left.
• Camera shake may occur due to insufficient light. Use the flash, mount the camera on a tripod, or otherwise secure
the camera in place.
Turn the power off and on
again • A problem with the lens caused an error.
640(Fine) is not available • 640(Fine) size movies can be recorded only using “Memory Stick PRO.” Insert a “Memory Stick PRO” or set the
image size to other than [640(Fine)].
Enable printer to connect • [USB Connect] is set to [PictBridge], however the camera is connected to a non-PictBridge compliant device. Check
the device.
• Depending on the circumstances, the connection may not be established. Disconnect and connect the USB cable
again. If an error message is indicated on the printer, refer to the operating instructions supplied with the printer.
Connect to device • You tried to print images before the printer connection was established. Connect to a PictBridge compliant printer.
No printable image • You tried to execute [DPOF image] without checking the mark.
• You tried to execute [All In This Folder] while selecting the folder that stores only movies. You cannot print movies.
Printer busy • Since the printer is busy, it cannot receive print requests. Check the printer.
Paper error • A paper error occurred, such as paper-out, paper-jam, etc. Check the printer.
Ink error • An ink error occurred. Check the printer.
Printer error • The camera received an error from the printer. Check the printer, or check if the image you want to print is corrupted.
• The data transmission to the printer may not be completed yet. Do not disconnect the USB cable.
Message Meaning/Corrective Action