8 power management setup, 7-3 super io configuration – AMD Socket AM2+ Quad Core AMD Processor SB750 User Manual
Page 34

29
Press Enter to set values for sub-items as: Legacy USB Support, USB 2.0 Controller Mode
BIOS EHCI Hand-OFF.
3-7-3
Super IO Configuration
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Super IO Configuration
Configure F71863 Super IO Chipset
Help Item
Onboard Floppy Controller Enabled
Serial Port 1 Address 3F8/IRQ4
Serial Port 2 Address 2F8/IRQ3
Serial Port Mode IrDA
Allows BIOS to Enable or
Disable Floppy Controller
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Onboard Floppy Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system
board and you wish to use it. If you install add-on FDC or the system has no floppy drive,
select Disabled in this field. The settings are: Enabled and Disabled.
Serial Port1 /Port Address
Use this item to select serial port address for serial port one.
Serial Port2 Mode
The optional settings are: Normal; IrDA (1.6 ns); IrDA(3/16 bit).
3-8 Power Management Setup
The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Power Management Setup
Power Management Feature
Help Item
Power Management Configuration Press Enter
Power management/APM Enabled
Suspend Time Out Disabled
Power Button Mode On/Off
Video Power Down Mode Suspend
Hard Disk Power Down MODE Suspend
Hard Disk Time Out (Minute) Disabled
Restore on AC Power Loss Disabled
RTC Resume Disabled
Disable/Enable
RTC to generate a wake event
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Advanced ACPI Configuration
Use this section to configure additional ACPI options.
Power Management/APM
Use this item to enable or disable AMI based power management and APM support.
Suspend Time Out
If it is set Enabled and no activity during this time period, the BIOS will place the system into
suspend low power state. The optional settings are: Enable; 1~64 minutes.
Power Button Mode
The optional settings are: On/Off; Suspend.
Video Power Down Mode
The optional settings are: Disabled; Standby and Suspend.