AMD Socket AM2+ Quad Core AMD Processor SB750 - Manual (Page 20)

15
(3) PS/2 Mouse & PS/2 Keyboard Connector: KB
The connectors are for PS/2 keyboard and PS/2 Mouse.
(4) USB Port connector: CN5/ UL1 for USB
The connectors are 4-pin connector that connects USB devices to the system board.
(5) LAN Port connector: UL1 for RJ45 LAN
The connector is standard RJ45 connector for Network. It supports
10M/100Mb/1000Mb s data transfer rate
(6) Audio Line-In, Lin -Out, MIC, RS-Out, CS-Out，SS-Out connector : J1
These Connectors are 6 Phone-Jack for LINE-OUT, LINE-IN, MIC, RS-Out, CS-Out，
SS-Out audio connections.
Line-in : (BLUE) Audio input to sound chip
Line-out : (GREEN) Audio output to speaker
MIC : (PINK) Microphone Connector
RS-OUT : (BLACK) Rear-Surround audio output
CS-OUT : (ORANGE) Center/ Subwoofer audio output
SS-OUT: (GRAY) Side-Surround audio output
(7) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
Floppy Drive Connector
Pin 1
FDD
(8) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
USB USB
PS/2 Mouse
PS/2 Keyboard
RS-Out
Line-OUT
CS-Out
SS-Out
MIC-IN
VGA Connector
DVI Connector
Line-IN
HDMI
ESATA
RJ-45
Coaxial
SPDIF_OUT
Optical
SPDIF_OUT