Atlas Air Compressor - Manual (Page 60)

Instruction book
2920 1521 00 60
5. If it is desired to modify the time, press the key "Modify". If not, press the key "Menu" to return to
the submenu.
6. After pressing the key "Modify", the first field (14) will blink. Modify the hours using the ↓ or ↑
keys. Then press the tabulator key (5) to go to the next field (i.e. 30). The setting of this field can
now be modified with the
↓ or ↑ keys.
7. The bottom line of the display will show two options:
- "Program" to program the new setting
- "Cancel" to cancel the new setting
8. Proceed in a similar way for the other parameters to be modified.
8.12.1 Programming compressor control modes
Compressor control modes
The compressor can be controlled locally, remotely or via a local area network (LAN – consult Atlas
Copco).
Procedure
1. Starting from the Main screen (see section 8.1.2):
- press the key "Menu" (F1)
- press the ↓ key until the option "Modify parameters" is followed by a horizontal arrow
- press the tabulator key (5) to activate the menu
2. Use the ↓ key to scroll until the option "Configuration" is followed by a horizontal arrow.
3. Press the tabulator key (5): The first option shown is "C.C.M." (Compressor Control Mode),
followed by the actual setting. Following screen is shown:
C.C.M. Local Control ┤
Pressure Band Selected Pressure Band 1
Node ID 31 ↓
Menu Modify
F1 F2 F3
Fig. 8.18 Compressor control mode menu
4. Press the key "Modify" and use
↓ or ↑ keys to select the desired control mode. Press the
"Program" key to program or the "Cancel" key to cancel the modification.
8.13 Service menu
Function
-
To reset the service plans which are carried out.
- To check for both the next service plans to be carried out and to find which service plans were
carried out previously.