Atlas Air Compressor - Manual (Page 59)

Instruction book
2920 1521 00 59
2. Use the ↓ key to scroll until the option "Clock function" is followed by a horizontal arrow. Press the
tabulator key (5), following screen appears:
Clock Function
Not activated →
Menu Modify Delete
F1 F2 F3
Deleting all commands
Press the key "Delete" (F3) in the screen above. A question to confirm the deleting operation will
appear.
Deleting all commands related to a specific day
Scroll through the display until the desired day is followed by a horizontal arrow. Press the key
"Delete" (F3). A question to confirm the deleting operation will appear.
Deleting a specific start/stop/pressure band command
Scroll through the display until the desired start, stop, pressure band 1 or pressure band 2 command
line is followed by symbol ┤. Press the key "Delete" (F3). A question to confirm the deleting operation
will appear.
8.12 Configuration menu
Function
To reprogram a number of parameters. See Fig. 8.1.
Procedure
1. Starting from the Main screen (see section 8.1.2):
- press the key "Menu" (F1)
- press the ↓ key until the option "Modify parameters" is followed by a horizontal arrow
- press the tabulator key (5) to activate the menu
2. Use the ↓ key to scroll until the option "Configuration" is followed by a horizontal arrow.
3. Press the tabulator key (5): The first option shown is "C.C.M" (Compressor Control Mode). If
another option is desired, scroll through the display (using ↓ or ↑ keys) until the option is followed
by symbol ┤.
4. In case of option "Time", the first line indicates the actual setting, e.g. 14:30 followed by symbol ┤.