beautypg.com

Atlas Air Compressor User Manual

Page 13

background image

Instruction book

2920 1521 00

13

1.5.6 Display – keys

Compressor Outlet

7.0 bar

Compressor Running

Menu

- - - -

F1 F2 F3


Fig. 1.12 Typical example of a display

Operating condition of a compressor module
The symbols shown above key F3 indicate the operating condition of each control module, see also section
8.1.2:

Symbol Indicates

-

that the compressor module is available (ready to run), each
symbol stands for a compressor module (the left symbol stands for
the lowest mounted module, the right symbol stands for the
highest module)

that the compressor module is running

- (blinking)

that the compressor module is not available (due to minimum stop
time or too many starts)

* (blinking)

that the compressor module is shut-down



Scroll keys (3-Fig. 1.11)
These keys, labelled with vertical arrows, allow to scroll through the display.

As long as a downwards pointing arrow is shown at the utmost right position of the display, the key (3) with
the same symbol can be used to see the next item.

As long as an upwards pointing arrow is shown at the utmost right position of the display, the key (3) with the
same symbol can be used to see the previous item.

Tabulator key (4-Fig. 1.11)
This key, labelled with two horizontal arrows, allows the operator to go to the next field of the display, e.g.
during modifying of programmable parameters.

1.5.7 Function keys (5-Fig. 1.11)

The keys are used:
-

To call up or program settings

-

To reset an active shut-down or service message, or an emergency stop

-

To have access to all data collected by the regulator


The function keys allow to make the required selection from a menu of possibilities. The functions of the keys
vary depending on the displayed menu. The actual function is abbreviated and indicated on the bottom line of
the display just above the relevant key. Only the active and relevant functions at a moment are shown:

Designation Function
Back

To return to a previously shown option or menu

Cancel

To cancel a programmed setting when programming parameters

Delete

To delete compressor start/stop commands

Extra

To find the module configuration of the regulator

Help

To find the Atlas Copco internet address

Limits

To show limits for a programmable setting

Mainscreen

To return from a menu to the main screen