Message lists, Warning messages – Sony VPL-VW1100ES User Manual
Page 61
61
Ot
h
e
rs
When a warning indicator other than the above starts flashing, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
Warning messages
ON/STANDBY flashes in
red. (A repetition rate of 5
flashes)
c The lens protector is not fully open. Turn the power of the unit
off and then on again. If the lens protector still does not fully
open, consult with qualified Sony personnel.
Tip
In an urgent situation, refer to the illustration below to open the lens
protector with your hands. Press the
?
/
1
(ON/STANDBY) button to
turn the power on and operate the unit.
Note
Message Lists
Message
Cause and Remedy
High temp.! Lamp off in 1
min.
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes
Frequency is out of range!
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the unit (
Please replace the Lamp.
c It is time to replace the lamp. Replace the lamp (1 page 63).
c If this message appears again after you replace the lamp, the
lamp replacement process is not complete. Check the lamp
replacement process (
To clear this message, press any button either on the remote control
or the control panel of the unit once.
Projector temperature is
high. Cooling Setting
should be “High” if
projector is being used at
high altitude.
c Check to ensure that the ventilation holes on the unit are not
covered (
c When using the unit at high altitude, set “Cooling Setting” to
“High” (
When temperature inside the unit remains high, “Cooling Setting” is
switched to “High” in 1 minute, then the fan speed increases.
Symptom
Cause and Remedy
Note
Note