A&D Waterproof Digital Platform Scale HW-60KV-WP - Manual (Page 47)

HV-WP/HW-WP Series Page 45 15. The Function Table
Item Display Meaning and purpose
Ａ
f6 5
When the display value becomes stable, the scale compares the
display value. It does not compare on an unstable condition. A
A
f6 6
When the display value becomes stable when not nearly-zero
after pressing the
SET switch, the scale compares the display value.
It does not compare on an unstable condition. If the
SET
switch is
pressed again, the scale stops the comparison.
A
A
A
f6 7
When the display value becomes stable when not nearly-zero,
the scale compares the value. A
A
f6 8
Simple batch function. (Refer to section 13.) Ａ
Comparator
f6 9
Full/dribble batch function. (Refer to section 12.) Ａ
The condition of the buzzer on option OP-03 by comparator
function or full/dribble batch function.
Ａ
Ａ
f7 0 #
No buzzer. Ａ
f7 1 The buzzer sounds at LO. Ａ
f7 2 The buzzer sounds at OK. Ａ
f7 3
The buzzer sounds at LO and OK.
Ａ
f7 4
The buzzer sounds at HI. Ａ
f7 5
The buzzer sounds at LO and HI. Ａ
f7 6 The buzzer sounds at OK and HI. Ａ
f7 7 The buzzer sounds at LO, OK and HI. Ａ
Buzzer
f7 8
The buzzer sounds at finishing the full/dribble batch process. Ａ
The condition of the accumulation function Ａ
f8 0 #
Accumulation function not used. A
f8 1
The scale accumulates the data, if the
F
switch is pressed, when
the display becomes a positive stable value without nearly-zero.
Next accumulation can be performed after the display becomes
nearly-zero or a negative value.
A
A
A
A
f8 2
The scale accumulates the data, if the F switch is pressed, when the
display becomes a stable value without nearly-zero. Next
accumulation can be performed after the display becomes nearly-
zero.
A
A
A
f8 3
When the display becomes a positive stable value, the scale
accumulates the data automatically. Next accumulation can be
performed after the display becomes nearly-zero or a negative value.
A
A
A
f8 4
When the display becomes a stable value, the scale accumulates
the data automatically. Next accumulation can be preformed after
the display becomes nearly-zero.
Use
Recording number and mass of articles removed form the
weighing pan. (Put articles on the weighing pan. Press
TARE
switch at each removal.)
A
A
A
A
A
Accumula-
tion func-
tion
f8 5
At each finish of the full/dribble batch function, the scale
accumulates the data automatically.
Use
Packing articles like a powder. used for recording the bag
number and total mass.
A
A
A
A
The "#" is factory settings. The "nearly-zero" is within ±4 digits from zero point in the unit of kg.