A&D Waterproof Digital Platform Scale HW-60KV-WP - Manual (Page 10)

Page 8 HV-WP/HW-WP Series 5. Installing the Scale
5. 5. 5. 5. Installing the Scale Installing the Scale Installing the Scale Installing the Scale
This procedure includes all of the steps for installing the HV-WP series and HW-WP
series. Therefore, on some products, there are some unnecessary steps.
Step 1 Connect the indicator unit to the pole with the
accesory knobs and rubber washers.
Step 2 Take the base unit and pole out, taking care
that the load-cell cable is not pulled.
Step 3 Put the weighing pan on the base unit.
Step 4 Insert the remainder of the load cell cable
into the pole. Attach the pole to the bracket
of the base unit so as not to damage the load
cell cable. Affix the pole to the bracket using
two 3mm Allen screws.
Step 5 Select the place for installing the scale. Also
consider "4. Caution" on page 7.
Step 6 Adjust the level of the base unit by using the
"Bubble spirit level" and "Leveling foot".
Step 7 Ground the scale using the earth terminal.
Caution
Please confirm that the local voltage and
the receptacle type are correct for your
scale.
Step 8 Adjust the angle of the indicator unit using
the knobs on the side of indicator unit.
Step 9 Check the weighing accuracy. If the scale
needs calibration, refer to "14. Calibration".
on page 39.