Swiftech MCRES MICR0 REV2 User Manual
Mcres-micro rev2 installation guide
Copyright Swiftech 2008 – All rights reserved – Last revision date: 10-24-08
Rouchon Industries, Inc., dba Swiftech – 3700 industry ave., suite 104 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
[email protected] – URL:
http://www.swiftech.com
- Information subject to change without notice
MCRES-Micro Rev2 Installation guide
This product is intended for expert users. Please consult with a qualified technician for installation. Improper
installation may result in damage to your components. Swiftech assumes no liability whatsoever, expressed
or implied, for the use of these products, nor their installation. The following instructions are subject to
change without notice. Please visit our web site at
ates.
Figure 1
Product Description
The MCRES-MICRO is a small form factor reservoir designed for liquid-cooled personal computers.
The device features four 1/4” NPSM (fully compatible with 1/4” BSPP/G1/4 standard) threaded ports, and is
shipped with two sets of nylon hose barbs, 3/8” and ½” to accommodate most high-flow systems.
The port usage is defined as follows:
Upper side port: “Inlet” as shown in figure 1 is the return line from the system
Lower side port: “Outlet (to pump)” shown in figure 1 should always be connected to the
pump inlet (directly if possible to facilitate filling of the system)
The fill-port located on top of the unit is used to fill it up with coolant, and sealed with a
chrome plated brass plug.
The alternate port is also sealed with a chrome plated brass plug, and can be used as:
An alternate outlet providing a straight tube routing to a pump located underneath
To feed a second pump