Installation of the cooling components, Ii. installation of the cooling components – Swiftech H20 220 APEX ULTIMA User Manual
Page 5
From a performance standpoint there is very little performance to be gained from strictly controlling the component
sequence: the maximum delta T (difference in temperature) between any two points of the liquid cooling circuit does not
exceed 1ºC. Whenever possible, performance oriented users will typically want to route the radiator discharge(s) tube(s) to
the inlet of the CPU cooler, since the fluid exiting the radiators is always the coolest.
Devices:
(1) CPU cooler + (1) Radiator + Pump-reservoir assembly
Connect:
Pump discharge to radiator inlet
Radiator discharge to CPU cooler inlet
CPU cooler discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
Alternatively,
Connect
Pump discharge to CPU cooler inlet
CPU cooler discharge to radiator inlet
Radiator discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
Devices
(1) CPU cooler + (1) VGA cooler + (1) Radiator + Pump-reservoir assembly
Connect:
Pump discharge to VGA Cooler inlet
VGA cooler discharge to radiator inlet
Radiator discharge to CPU cooler inlet
CPU cooler discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
Alternatively,
Connect:
Pump discharge to CPU cooler inlet
CPU cooler discharge to VGA cooler inlet
VGA cooler discharge to radiator inlet
Radiator discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
Devices:
(1) CPU cooler + (1) VGA Cooler + (1) chipset Cooler + (1) Radiator + Pump-reservoir assembly
Connect:
Pump discharge to chipset cooler inlet
Chipset cooler discharge to VGA cooler inlet
VGA cooler discharge to radiator inlet
Radiator discharge to CPU cooler inlet
CPU cooler discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
Alternatively,
Connect:
Pump discharge to CPU cooler inlet
CPU cooler discharge to chipset cooler inlet
Chipset cooler discharge to VGA cooler inlet
VGA cooler discharge to radiator inlet
Radiator discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
Devices:
Dual CPU cooler and VGA cooler (SLI) configurations
Connect:
CPU coolers in series: CPU cooler (1) discharge to CPU cooler (2) inlet
VGA coolers in series: VGA cooler (1) discharge to VGA cooler (2) inlet
Devices:
Dual Radiators: A second radiator can be added anywhere in the loop in series with the other components,
for example
Connect
Pump discharge to radiator (1) inlet
Radiator (1) discharge to VGA cooler inlet
VGA Cooler discharge to chipset cooler inlet
Chipset cooler discharge to radiator (2) inlet
Radiator (2) discharge to CPU cooler inlet
CPU cooler discharge to reservoir inlet
Reservoir discharge to pump inlet – MANDATORY!
II. Installation of the cooling components
Warning!
Placement of the cooling components may vary depending on your chassis and motherboard configurations. A mock-up
installation is thus necessary to estimate the length of the different sections of tubing that will be required between each component.
The following is the recommended sequence of components installation.
1.
Radiator and fan
2. Water-block(s)
3. Pump
4. Reservoir
Copyright Swiftech 2008 – All rights reserved – Last revision date: 10-29-08- Information subject to change without notice – URL:
http://www.swiftech.com
Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
5 of 17