Swiftech H20 120 R3 - Manual (Page 19)

4. Connecting the pump to the circuit:
The pump’s inlet and outlet are 3/8” in outside diameter. Use with 3/8” ID (1/2” OD) tubing, or 10mm
ID (12mm OD) for Europe.
5. Performance & Specifications
Nominal voltage 12 V DC
Operating voltage range 9 to 13.2 VDC
Nominal power (@ 12 V) 8.3 W
Nominal current (@ 12 V) .69 amps
Motor type
Electronically commutated,
brushless DC, spherical
motor
Nominal head (@ 12 V) 13.05 ft (4 m)
Nominal discharge (@ 12 V) ~ 92.4 GPH (350 LPH)
Connection size 3/8" barbs (10mm)
Maximum pressure 22 PSI (1.5 BAR)
Temperature range Up to 140°F (60°C)
Electrical connector Molex 4 pin
Weight 7.3 oz (207 gr.)
Our noise measurement (non
lab environment) 24 ~ 26 dBA in a quiet room
@ 2'
MTBF (Mean Time Between
Failures)
50,000 Hours
RPM sensor 3 pin connector
6. Permanent installation to the chassis, and exploded view
Drill two 0.312” (8mm) holes into panel, 2.52” (64mm) apart. Snap grommet into each
hole. Tighten the provided screws until the pump neoprene pad is slightly and evenly
compressed by approximately 1/8” (2~3mm) or less.
MCP350 PUMP
∅0.313"
(8mm)
Grommet
Washer
#6 x 7/8"
Philips screw
2.52"
(64mm)
Neoprene
pad
DISCLAIMER: Swiftech assumes no liability whatsoever, expressed or implied, for the use of this product, and more specifically for
any, and all damages caused by the use of this product to any other devices in a personal computer, whether due to product failure,
leak, electrical shorts, and or electro-magnetic emissions. WARRANTY: This product is guaranteed for a period of 24 months from
date of purchase for defects in material, and workmanship. Guarantee consists of replacing defective parts with new or reconditioned
parts. Guarantee is considered void in case of improper use (*)(**)(***), handling or negligence on the part of user. Original invoice
showing date and place of purchase is required for exercise of the warranty.
(*) WARNING: DO NOT ATTEMPT TO RUN THIS PUMP DRY.
THIS WILL CAUSE IMMEDIATE AND PERMANENT DAMAGE TO THE PUMP. (**) EXCESSIVE WEAR DUE TO INNAPROPRIATE FLUIDS. (***)
EXCESSIVE RESTRICTION TO THE PUMP’S INLET
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All
content Copyright Swiftech 2004 – Last edited 2-1-05 – Subject to revision without notice - 19 of 41 -