Swiftech MCW6000 NX User Manual
Parts list
1.
Preparing your Motherboard
Remove the existing heat sink and carefully clean the CPU.
Apply thermal compound: lightly coat the CPU with the provided Céramique™ thermal compound. Follow this link
nstructions.
Rub some compound in base of water-
block first, and then clean off with lint-
free cloth
Apply small amount of
compound on the CPU heat
spreader
Parts list
Parts
QTY
PARTS
QTY
MCW6000-NX™ water-block
1
6-32 x 7/8” Philips screws
4
Worm drive clamps
2
.600 x .250 Nylon spacer
4
SP4 hold-down plate
1
4-40 Nylon retaining washers
4
Céramique thermal compound
1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation
may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of
these products, nor their installation. The following instructions are subject to change without notice. Please visit our web
for updates.
ITEM NO. QTY. PART NO.
DESCRIPTION
1
1 S604-NOCONA
Motherboard & CPU assembly
3
1 spring-backplate
retention spring (provided by motherboard vendors)
4
1 chassis
5
4 STANDOFF-0.187
6
1 MCW6000-FLAT
MCW6000 waterblock flat base
7
1 SP4-Bckt
SP4 Holding plate for Intel Pentium 4 and Xeon
9
4 90272A152-6-32x7-8-philips 6-32 x 7/8" (22mm) Philips screw
10
4 4-40 nylon retaining washer
4-40 nylon retaining washer
11
4 custom_spacer-r1
Nylon spacer .600 x .250 (15 x 6mm)
6
7
1
1 1
1 0
3
5
4
9
Figure 1
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-
8769 - E Mail: [email protected] – URL:
http://www.swiftnets.com
- Information subject to change without notice
Page 1 of 2