Swiftech MCW6000 2 PX User Manual
Parts list, Figure 1
Parts list
Parts
QTY
PARTS
QTY
MCW6000 or 6002-PX™ water-block
1
6-32 x 1 ¼” Philips screws
4
Worm drive clamps
2
Springs
4
SP4 hold-down plate
1
Standoffs
4
4-40 Nylon retaining washers
4
Black fiber washers
8
Locknuts
4
Céramique thermal compound
1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation
may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of
these products, nor their installation. The following instructions are subject to change without notice. Please visit our web
for updates.
The MCW6000 or 6002-PX water-blocks can be installed using two different
methods:
Using the spring-loaded screws and standoffs included with the water-block (fig. 1 below)
Using the plastic retention frames and spring clips included with most motherboards (fig. 2 page 2)
Assembly using our
spring-loaded screws
and standoffs
ITEM NO.
PART NO.
DESCRIPTION
1
DUAL-XEON-BOARD
Motherboard
2
STANDOFF
swtainless steel hexagonal 1/4" standoff
3
6-32-LOCKNUT
6-32 LOCKNUT
4
FW140X250X0215FB BLK
black fiber washer
5
MCW6000-P-with-bracket
MCW6000-P water-block assembly
a MCW6000-FLAT
MCW6000 waterblock flat base
b SP4-Bckt
SP4 Holding plate for Intel Pentium 4 and Xeon
6
91772A154-phil6x32x1.125
6-32 x 1 1/4" philips scfrew
7
70750
0.042 diam Heavy Duty spring
8
4-40 nylon retaining washer
4-40 nylon retaining washer
6
7
8
2
4
3
1
FLUID INLET
FLUID DISCHARGE
Figure 1
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-
8769 - E Mail: [email protected] – URL:
http://www.swiftnets.com
- Information subject to change without notice
Page 1 of 3