Swiftech MCW20 R User Manual
Parts list, I. preparation steps common to both platforms
Table of contents
Document Outline
- MCW20-R™ Water-block
- Intel( Platforms
- AMD( platforms
- Remove the existing heat sink
- Carefully clean the processor, using alcohol
- Install the 4 neoprene pads as shown figure 8. This steps is only necessary if the processor core is exposed. If the chipset features a heat spreader (a large lid covering the entire area of the chipset), then the neoprene pads MUST not be installed.
- Lightly coat the processor with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using preferably a razor blade, or a credit card, held between thumb and index at a 45( angle