Blodgett DFG-100 XCEL - Manual (Page 19)

17
Operation
SSD - Solid State Digital Control
ContRoL DESCRiPtion
1. SELECTOR SWITCH - controls power to the oven for
high fan, low fan or cool down.
2. DISPLAY - displays time or temperature and other in-
formation related to oven function.
3. HEAT LAMP - lights when heater is on.
4. PULSE LAMP - lights when Pulsed Fan Mode is
turned on.
5. HOLD LAMP - lights when Hold Mode is turned on.
6. DIAL - used to enter set points in display
7. START/STOP KEY - starts or stops the timer.
8. TIME KEY - used to show time in the display.
9. TEMP KEY - used to show set temperature in the dis-
play.
NOTE: Actual temperature is shown while the
TEMP key is held down.
10. HOLD KEY - turns Hold Mode on or off.
11. PULSE KEY - turns Pulse Mode on or off.
12. LIGHTS SWITCH - controls interior lights.
13. RATE SWITCH - switches oven between standard
rate (60,000 BTU) and high rate (80,000 BTU) while
in high fan.
NOTE: High rate is disabled with low fan.
14. GAS ON/OFF SWITCH - press to shut off gas to the
oven.
Figure 12