Blodgett Mark V-100 - Manual (Page 15)

13
Operation
SSd Solid State digital control
HIGH
FAN
LOW FAN
REPLACE WITH 10 AMP
TIME DELAY FUSES
WARNING 10 AF 10 AF
DISCONNECT FROM THE SOURCE OF
SUPPLY BEFORE SERVICING
www.blodgett.com
Mark V
Solid State
1
2
3
8
7
10
4
5
6
9
11
Figure 11
controL deScriPtion
1. SELECTOR SWITCH - turns power to the oven on or off.
Allows selection of Cook or Cool Down Modes and fan
speed (if applicable).
2. DISPLAY - displays time or temperature and other infor-
mation related to oven function.
3. HEAT LAMP - lights when heater is on.
4. PULSE LAMP - lights when Pulsed Fan Mode is turned
on.
5. HOLD LAMP - lights when Hold Mode is turned on.
6. DIAL - used to enter set points in display
7. START/STOP KEY - starts or stops the timer.
8. TIME KEY - used to show time in the display.
9. TEMP KEY - used to show set temperature in the display.
NOTE: Actual temperature is shown while the TEMP
key is held down.
10. HOLD KEY - turns Hold Mode on or off.
11. PULSE KEY - turns Pulse Mode on or off.
ProGraMMinG
to set the cook temperature:
1. Press TEMP (9) key.
2. Rotate dial (6) to enter temperature.
to set the cook time:
1. Press TIME (8) key.
2. Rotate the dial (6) to enter time.
NOTE: Time is entered in hours : minutes or minutes :
seconds.
to set the hold time:
1. Press HOLD key (10) to turn hold mode on.
NOTE: HOLD light is on.
2. Rotate dial (6) to enter the hold temperature.
3. Press START/STOP key (7)
to set the pulse time:
1. Press PULSE KEY (11) to turn pulse mode on.
NOTE: Pulse light is on.
2. Rotate DIAL (6) to enter the pulse time. Pulse time is a
portion of the pre-set cook time.