Allied Telesis AT-MR820T - Manual (Page 29)

AT-MR420T and AT-MR820T Installation Guide
7
Attach a second 10Base-T UTP RJ45 connector to 10Base-T network
port 2. The Port 2 LINK OK LED on the front panel should now light,
provided the 10Base-T device on the opposite end of the UTP cable is
operational.
AUI Network Port
Each repeater has one AUI port to accommodate a 10Base5 (standard
or thick Ethernet cable) connection to the network backbone using an
AUI.
LED Status Indicators
The front panel indicators are grouped into the following categories:
❑ Network Load
❑ Port Status
❑ Hub Status
Network Load Indicators
Eight Network Load LEDs indicate the percentage of network
utilization. Figure 4 shows these LEDs.
Figure 4: Network Load Indicators
MRx20T(UTP)Ver6_Book Page 7 Thursday, April 3, 1997 5:18 PM