Allied Telesis AR400 SERIES Software Release 2.7.1 - Manual (Page 75)

Physical and Layer 2 Interfaces 75
Software Release 2.7.1
C613-02021-00 REV F
Asynchronous Port
Asynchronous ports are normally used to connect a terminal to the router for
configuration purposes. The default values for configurable parameters are
modified by entering the command:
SET ASYN=port-number option
The factory default settings for asynchronous ports are shown in Table 8 on
page 75.
For more information about asynchronous ports, see the Hardware Reference
or the Interfaces chapter in the Software Reference.
For more information about configuring PPP interfaces across an asynchronous
interfaces, see the Point to Point Protocol (PPP) chapter in the Software
Reference.
Table 8: Factory defaults for configurable parameters for asynchronous ports.
Option Default setting
ATTENTION BREAK
CDCONTROL IGNORE
DATABITS 8
DEFAULTSERVICE FALSE
DTRCONTROL ON
ECHO ON
FLOW HARDWARE
HISTORY 30
INFLOW HARDWARE
IPADDRESS NONE
IPXNETWORK NONE
MAXOQLEN 0 (Unrestricted)
MTU 1500
NAME Asyn #
OUTFLOW HARDWARE
PAGE 22
PARITY NONE
PROMPT DEFAULT (CMD>)
SECURE ON
SERVICE NONE
SPEED AUTO
STOPBITS 1
TYPE VT100