Allied Telesis AT-WA7400/NA - Manual (Page 50)

Chapter 3: Managing Access Points and Clusters
50
Note
In some situations it is possible for the cluster to become out of
sync. If after removing an access point from the cluster, the access
point list still reflects the deleted access point or shows an
incomplete display; refer to the information on cluster recovery in
“Cluster Recovery” on page 261.
Adding an Access
Point to a Cluster
To add an access point that is currently in standalone mode back into a
cluster, do the following.
1. Go to the AT-WA7400 Management Software web pages for the
standalone access point. (See “Navigating to an Access Point by
Using its IP Address in a URL” on page 52.)
The web pages for the standalone access point are displayed.
2. From the main menu, select Cluster > Access Points.
3. Click Join Cluster.
The Summary of Settings page is redisplayed, as shown in Figure 18,
with the settings of the access point that is now part of the cluster.
Figure 18. Settings of Access Point that Joined the Cluster