Allied Telesis AT-WA7400/NA - Manual (Page 237)

AT-WA7400 Management Software User’s Guide
237
Note
The following example assumes that you are using the built-in
authentication server that is shipped with the AT-WA7400 Wireless
Access Point. If you are setting up EAP/PEAP on a client of an
access point that is using an external RADIUS server, the client
configuration process will differ somewhat from this example
especially with regard to certificate validation.
If you configured the AT-WA7400 Wireless Access Point to use WPA/
WPA2 Enterprise (RADIUS) security mode and to use either the built-in
authentication server or an external RADIUS server that uses EAP/PEAP,
perform the following procedure:
1. On the Security Settings page (Figure 12), verify that the Security
Mode is set to WPA/WPA2.
Figure 12. Security Settings Page