Set security to plain text, Set security to static wep, Set the security mode – Allied Telesis AT-WA7400/NA User Manual

Page 307: Set the transfer key index, Set the key length

AT-WA7400 Management Software User’s Guide

307

channel 6

tx-power 100

tx-rx-status up

beacon-interval 100

rts-threshold 2347

fragmentation-threshold 2346

load-balance-disassociation-utilization 0

load-balance-disassociation-stations 0

load-balance-no-association-utilization 0

ap-detection off

station-isolation off

frequency 2437

wme on

Set Security to Plain Text

AT-WA7400# set interface wlan0 security plain-text

Set Security to Static WEP

Set the Security Mode

AT-WA7400# set interface wlan0 security static-wep

Set the Transfer Key Index

The following commands set the Transfer Key Index to 4.

AT-WA7400# set interface wlan0 wep-default-key 1

AT-WA7400# set interface wlan0 wep-default-key 2

AT-WA7400# set interface wlan0 wep-default-key 3

AT-WA7400# set interface wlan0 wep-default-key 4

Set the Key Length

For the CLI, valid values for Key Length are 40 bits or 104 bits.