Allied Telesis AT-WA7400/NA - Manual (Page 296)

Appendix D: Command Line Interface (CLI) for Access Point Configuration
296
To view the current log settings:
AT-WA7400# get log
Field Value
--------------------------
depth 15
relay-enabled 0
relay-host
relay-port 514
When you start a new access point, the Log Relay Host is disabled. From
the above output for the
get log command, you can identify the following
about the Log Relay Host (syslog server):
ˆ The syslog server is disabled (because “relay-enabled” is set to “0”)
ˆ No IP address or Host Name is specified for the syslog server.
ˆ The access point is listening for syslog messages on the default port
514
Enable / Disable Log Relay Host
To enable the Log Relay Host:
AT-WA7400# set log relay-enabled 1
To disable the Log Relay Host:
AT-WA7400# set log relay-enabled 0
Specify the Relay Host
To specify the Relay Host, provide either the IP address or a DNS name for
the Log Relay Host as parameters to the set log relay-host
command as shown below.
ˆ To specify an IP address for the syslog server:
set log relay-host IP_Address_Of_LogRelayHost
Where IP_Address_Of_LogRelayHost is the IP address of the Log
Relay Host.
For example:
AT-WA7400# set log relay-host 10.10.5.220
ˆ To specify a Host Name for the syslog server: