Allied Telesis AT-GS900/8E - Manual (Page 42)

Chapter 2: Installation
42
Powering On a Switch
For power requirements, refer to “Power Specifications” on page 47.
Powering On an
AT-GS900/8
Switch
To power on an AT-GS900/8 switch, perform the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 16.
Figure 16. Power Cord Retaining Clip in the Up Position
2. Plug the power cord into the AC power connector on the back of the
switch, as shown in Figure 17.
Figure 17. Plugging in the AC Power Cord
3. Secure the power cord by lowering the retaining clip, as shown in
Figure 18.
100-240V
~
50-60Hz 0.6A
566
100-240V
~
50-60Hz 0.6A
100-240V
~
50-60Hz 0.6A