Allied Telesis AT-GS900/8E - Manual (Page 35)

AT-GA900/8 and AT-GA900/8E Gigabit Ethernet Switches Installation Guide
35
Installing the Power Cord Retaining Clip on the AT-GS900/8L Switch
To install the power cord retaining clip on the AT-GS900/8 switch, perform
the following procedure:
Note
Install the power cord retaining clip before you install the switch in a
rack.
1. Locate the power cord retaining clip, as shown in Figure 8.
Figure 8. Power Cord Retaining Clip
2. Locate the retaining bracket on each side of the AC power connector
on the back of the switch, as shown in Figure 9.
Figure 9. Power Cord Retaining Bracket
100-240V
~
50-60Hz 0.6A
Bracket