Allied Telesis AT-S84 - Manual (Page 93)

AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 93
Configuring the
LACP Port
Priority
The switch uses the port priority to determine which ports are to be active
and which are to be in standby mode in situations where the number of
ports in the aggregate trunk exceeds the highest allowed number of active
ports. The port with the lowest numerical value has the highest priority.
To configure the LACP port priority, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
2. From the Advanced Switch Configuration Menu, type T to select Trunk
Configuration.
The Trunk Configuration Menu is shown in Figure 22 on page 89.
3. From the Trunk Configuration Menu, type O to select Set Port Priority
The LACP Port Priority Menu is shown in Figure 23.
Figure 23. LACP Port Priority Menu
4. From the LACP Port Priority Menu, type S to select Set Port Priority.
The following prompt is displayed:
AT-9000/24 Local Management System
Trunk Configuration -> LACP Port Priority Menu
Port Priority
------- ----------
1 1
2 1
3 1
4 1
5 1
6 1
7 1
8 1
9 1
10 1
----------------------- -----------------------------
[S]et Port Priority
[N]ext Page
[P]revious Page [Q]uit to previous menu
Command>