Allied Telesis AT-S84 - Manual (Page 63)

AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 63
Enabling Authentication Traps
To enable SNMP authentication traps, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration menu, type N to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16.
Figure 16. SNMP Configuration Menu
3. Type E to select Enable/Disable Authentication Trap.
The following prompt is displayed:
Enable or Disable SNMP Authentication Trap (E/D)>
4. Type E to enable SNMP or D to disable SNMP. The default is Enabled.
AT-9000/24 Local Management System
Basic Switch Configuration -> SNMP Configuration Menu
SNMP Read Community: public
SNMP Write Community: private
Trap Authentication:
Enabled
SNMP Trap Receivers:
No.
Status IP Address Community
--- ----- -------------- ------------------------------------
1 Deleted
2 Enabled 149.35.8.42 Monitor
3 Deleted
4 Deleted
-------------------------------------------------------------------
Set SNMP [R]ead Community
[A]dd SNMP Trap Receiver
set SNMP [W]rite Community [D]elete SNMP Trap Receiver
[M]odify SNMP Trap Receiver [E]nable/Disable Authentication Trap
Enable/Disable SNMP [T]rap Receiver [Q]uit to previous menu
Command>