Allied Telesis AT-S84 - Manual (Page 174)

Chapter 12: 802.1x Network Access Control
174 Section I: Using the Menus Interface
Configuring 802.1x Network Access Control
To configure 802.1x network access control, perform the following
procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
2. From the Advanced Switch Configuration Menu, type X to select
802.1x Port Based Access Control Configuration.
The Port Based Access Control Configuration Menu is shown in
Figure 48.
Figure 48. Port Based Access Control Configuration Menu
AT-9000/24 Local Management System
Advanced Switch Configuration -> Port Based Access Control Configuration Menu
NAS ID : Nas1
Port No : 1
Port Status : Authorized
Port Control : Force Authorized
Transmission Period : 30 seconds
Supplicant Timeout : 30 seconds
Server Timeout : 30 seconds
Maximum Request : 2
Quiet Period : 60 seconds
Re-authentication Period : 3600 seconds
Re-authentication Status : Disabled
----------------------- -----------------------------------------
[N]AS ID
Server Time[o]ut [I]nitialize
[P]ort No [M]aximum Request [R]e-auth Initialize
Port [C]ontrol Q[u]iet Period [Q]uit to previous Page
[T]ransmission Period R[e]-auth Period
Supp[l]icant Timeout Re-[a]uth Status
Command>