Allied Telesis AT-S84 - Manual (Page 231)

AT-S84 Management Software User’s Guide
Section II: Web Browser Interface 231
ˆ The only valid setting for an optional SFP port is Auto-Negotiation.
Flow Ctrl
The current flow control setting on the port. The switch uses a special
pause packet to notify the end node to stop transmitting for a specified
period of time. The possible values are:
Enabled - The port uses flow control. This is the default setting for all
ports on the switch.
Disabled - The port does not use flow control.
MAC Address
The port’s MAC address. You cannot change this setting.
Note
You cannot configure back pressure on an individual port basis. To
configure back pressure on all ports, refer to “Viewing and
Configuring Multiple Ports” on page 226.
3. Click Apply.
4. To view or configure the parameter settings on another port, click Go
to Port and select the port from the list,
5. Repeat step 2 in this procedure to configure the settings
6. Click Apply.
To return to the front panel page, click Return To Front Panel.