Allied Telesis AT-S84 - Manual (Page 140)

Chapter 10: IGMP Snooping
140 Section II: Menus Interface
Configuring IGMP
To configure IGMP, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 4 on
page 32.
2. From the Advanced Switch Configuration Menu, type I to select IGMP
Snooping Configuration.
The IGMP Configuration Menu is shown in Figure 35.
Figure 35. IGMP Configuration Menu
3. Type E to select Enable/Disable IGMP Snooping.
The following prompt is displayed:
Enable or Disable IGMP snooping (E/D)>
4. Type E to enable IGMP snooping or D to disable IGMP snooping.
5. If you are activating the feature, type S to Set Age-Out Timer.
The following prompt is displayed:
AT-9000/24 Local Management System
Advanced Switch Configuration -> IGMP Configuration Menu
IGMP Snooping Status: Disabled
IGMP Snooping Age-Out Timer: 280 seconds
VLAN ID Multicast group address
------- ------------------------
----------------------- -----------------------------
[N]ext Page
[E]nable/Disable IGMP Snooping
[P]revious Page [S]et Age-Out Timer
[V]iew group members [Q]uit to previous menu
Command>