Allied Telesis AT-S84 - Manual (Page 253)

AT-S84 Management Software User’s Guide
Section II: Web Browser Interface 253
The VLAN Port Configuration page opens, as shown in Figure 76.
Figure 76. PVID Page
2. Click the PVID field of the port whose value you want to change and
enter the new PVID value for the port. The PVID must be equal to the
VID of the VLAN where you want the port to be an untagged member.
For example, to make Port 10 an untagged member of a VLAN that
has a VID of 12, you would change its PVID to 12.
Note
If you specify a PVID that does not correspond to any VIDs on the
switch, the management software creates a new VLAN with a VID
that equals the PVID. The VLAN is not assigned any name.
3. Click Apply.