Allied Telesis AT-CV1203 - Manual (Page 32)

Chapter 2: Installation
32
Powering On an AT-CV120x Chassis
The AT-CV120x chassis is shipped with one AC power adapter which
powers both slot 1 and slot 2.
Note
Use only power sources that are UL Listed (QQGQ or EPBU), TUV
Licensed or other Safety Agencies approved, and that are suitable
for country of use.
To power on an AT-CV120x chassis, perform the following procedure:
1. Plug one end of the power cord into the socket on the power adapter
and plug the other end of the power cord into a power outlet, as shown
in Figure 11.
Figure 11. Connecting the Power Adapter and Power Cord
2. Plug the pigtail connector from the power adapter into one of the two
power connectors on the back labeled 12VDC.
The chassis is now ready for network operations.
517
Plug into Wall Outlet
Plug Together
Power Adapter
Pigtail connector
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
E3
Pluggable Equipment. The socket outlet shall be installed near
the equipment and shall be easily accessible.
E5