Allied Telesis AT-8550SP - Manual (Page 62)

Chapter 2: Installation
62
Installing an Optional SFP Transceiver
To install an optional SFP transceiver in an AT-8550SP switch, perform
the following procedure:
Note
An SFP transceiver can be hot-swapped; you do not have to power
off a switch to install it.
1. Unpack the SFP transceiver from its shipping container and store the
packaging material in a safe location.
Note
You must use the original shipping material if you need to return the
module to Allied Telesis.
Warning
An SFP transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
module.
2. Check that the SFP transceiver includes the items listed below. If any
item is missing or damaged, contact your Allied Telesis sales
representative for assistance.
ˆ One SFP module
ˆ Installation Guide
ˆ Warranty card
Note
For fiber optic cabling specifications, refer to the SFP installation
guide provided with the module.
3. Follow these guidelines to ensure proper performance of your SFP
transceiver:
ˆ SFP transceivers are static sensitive. To prevent Electrostatic
Discharge (ESD) damage, follow your normal board and
component handling procedures.
ˆ SFP transceivers are dust sensitive. Do not remove the dust cover
from the port until you are ready to attach the fiber optic cable.
ˆ The most common source of contaminants in the optical bore is