Allied Telesis AT-GS950/8 - Manual (Page 36)

Chapter 2: Installation
36
Installing the Switch in a Rack
To install the AT-GS950/8 switch in a rack, perform the following
procedure:
1. If rubber feet are attached, remove them using a flat-head screwdriver.
2. Install a rack-mount bracket on one side of the switch using a Phillips
screwdriver and four of the rack-mount screws included with the
switch.
There are two ways to attach the brackets to the chassis. Attach the
brackets so the switch is flush with the front of the rack as shown in
Figure 9. Or, attach the brackets so the switch extends in front of the
rack as shown in Figure 10.
Figure 9. Attaching the Rack-Mount Bracket (Switch is Flush with Rack)
Figure 10. Attaching the Rack-Mount Bracket (Switch Extends From Rack)
3. Repeat step 2 to attach the remaining bracket to the other side of the
switch.
4. Mount the switch on a 19-inch rack using the two of the large screws
included with the package.
918
931