Allied Telesis AT-MC1008/SP - Manual (Page 47)

AT-MC1008 Series Installation Guide
47
Powering On the Media Converter
Once the AT-MC1008 Series converter is ready to be used, perform the
following procedure to power it on:
To power on an AT-MC1008 Series AC powered chassis, perform the
following procedure:
Note
The power adapter is not used if you install the AT-MC1008 Series
converter in an AT-MCR12 chassis.
1. Locate the power terminal block on the rear panel of the AT-MC1008
Series AC powered chassis.
2. Plug one end of the power cord to the power receptacle connector
labeled 12VDC, as shown in Figure 22.
Figure 22. Connecting Power Cord to an AT-MC1008 Series AC Powered
Chassis
12VDC
373