Allied Telesis AT-MC102XLPCI - Manual (Page 29)

AT-MC102XLPCI 100Mbps Media Converter Installation Guide
29
Installing a Network Adapter Card
The following instructions apply to installing AT-MC102XLPCI Media
Converter in most systems. For details about performing these tasks on
your particular system, refer to the manuals that were supplied with your
computer system.
Note
To perform this procedure, you need to provide a Phillips-head
screw driver.
To install an AT-MC102XLPCI Media Converter perform the following
procedure:
1. Read the Reviewing Safety Precautions on page 24 and follow the
Pre-Installation Checklist on page 25 before proceeding to the next
step.
2. If your computer is powered on, turn off the power.
3. When the system is completely shut down, unplug your computer.
4. Ensure that proper electrical grounding procedures have been
followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
5. Remove the system cover. See Figure 7 .
Figure 7. Removing the PC Cover