Allied Telesis AT-MC102XLPCI - Manual (Page 27)

AT-MC102XLPCI 100Mbps Media Converter Installation Guide
27
Replacing the
Bracket
The AT-MC102XLPCI Media Converter is shipped with the low-profile
bracket attached to the adapter and a separate standard-profile bracket.
You may need to replace the low-profile bracket attached to your adapter
with the standard profile bracket depending on your PC.
The following procedure describes how to remove the low-profile bracket
from the adapter and replace it with the standard bracket. You can also
use this procedure to remove the standard bracket and replace it with the
low-profile bracket.
To replace the low-profile bracket with the standard bracket, perform the
following procedure:
1. Remove the screws that attach the bracket to the adapter. See Figure
5.
Figure 5. Removing the Bracket
2. Align the tabs of the standard bracket with the holes on the adapter
and fasten the screws onto the adapter. See Figure 6.
Figure 6. Installing the New Bracket