Acnodes PC 6170 - Manual (Page 71)

PC 6170 User’s Manual
Appendix B
Power Supply Specification
Power Supply: FSP180-50PLA1 ( 180W, AC
110~230V Input)
ELECTRICAL REQUIREMENTS
OUTPUT ELECTRICAL REQUIREMENTS
The subject power supply will meet all electrical specifications below,
over the full operation temperature range and dynamic load
regulation.
OUTPUT RATING
Out p ut N o minal R e gu lation R i pp le/ N ois e Min Ma x
1 +3.3V ±5% 50mV 0.3A 10.0A
2 +5V ±5% 50mV 0.3A 16.0 A
3 +12V ±5% 120mV 1.5A 14.0 A
4 -12V ±10% 120mV 0.0 A 0.3A
5 +5VSB ±5% 50mV 0.0 A 2.0A
※ –12V,+3.3V, +5V,+12V will have the regulation to ±10% when all
load take off.
The +3.3V and +5V total output shall not exceed 61watts. The +3.3V,
+5V,and +12V total output shall not exceed 165watts and the total
output for this subject power supply is 180 watts. Ripple and noise
measurements shall be made under all specified load conditions
through a single pole low pass filter with 20MHz cutoff frequency.
Outputs shall bypassed at the connector with a 0.1uF ceramic disk
capacitor and a 10uF electrolytic capacitor to simulate system loading.
Power Supply Specification 63