Asus DELUXE SERIES M3A32-MVP - Manual (Page 61)

ASUS M3A32-MVP Deluxe Series 2-35
• For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 600 W.
• Do not forget to connect the 8-pin ATX +12 V power plug; otherwise, the
system will not boot.
• Use of a PSU with a higher power output is recommended when
configuring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
• If you are uncertain about the minimum power supply requirement for your
system, refer to the Recommended Power Supply Wattage Calculator
at http://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-us for details.
• The ATX 12 V Specification 2.0-compliant (500W) PSU has been tested
to support the motherboard power requirements with the following
configuration:
CPU: AMD FX-62
Memory 1024 MB DDR2-800 (x4)
Graphics card: PCI Express x16 NVIDIA 7900GTX
Serial ATA device: SATA hard disk drive (x2)
Optical drives: DVD-RW
10. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end
of the front panel audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition audio
capability.
• If you want to connect a high-definition front panel audio module to this
connector, set the Front Panel Support Type item in the BIOS setup to
[HD Audio]; if you want to connect an AC'97 front panel audio module
to this connector, set the item to [AC97]. By default, this connector is set
to [HD Audio]. See section 4.4.5 Onboard Devices Configuration for
details.
M3A32-MVP
DELUXE
®
M3A32-MVP DELUXE Analog front panel connector
AAFP
Legacy AC ‘97 audio
pin definition
HD Audio-compliant
pin definition
NC
MIC2
Line out_R Line out_L
NC
NC
MICPWR
NC AGND SENSE2_RETUR
POR
T1 L
POR
T2 R
POR
T2 L
SENSE1_RETUR
SENSE_SEND
POR
T1 R
PRESENCE# AGND