Asus DELUXE SERIES M3A32-MVP - Manual (Page 60)

2-34 Chapter 2: Hardware information
9. ATX power connectors (24-pin EATXPWR; 8-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
M3A32-MVP
DELUXE
®
M3A32-MVP DELUXE
Chassis intrusion connector
CHASSIS
+5VSB_M
B
Chassis Signal GND
(Default)
M3A32-MV
P
DELUXE
®
M3A32-MVP DELUXE ATX power connectors
EATXPWR EATX12V
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground GN
D
+12V DC
GN
D
+12V DC
GN
D
+12V DC
GN
D
+12V DC