Asus DELUXE SERIES M3A32-MVP - Manual (Page 155)

ASUS M3A32-MVP Deluxe Series 5-43
5.4.4 Marvell ® RAID configurations
The Marvell ® 6121 Serial ATA controller allows you to configure RAID 0 and RAID 1
sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two internal Serial ATA hard disk drives to the SATA connectors labeled
SATA_RAID1/2.
2. Boot up your computer, and press during POST to enter the BIOS
setup.
3. In the Advanced Menu, go to Onboard Devices Configuration, and enable
both Marvell 6121 SATA Controller and Marvell Option ROM.
4. Set Marvell IDE/RAID function to [RAID].
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
Onboard Devices Configuraiton
Serial Port1 Address [3F8/IRQ4]
Serial Port1 Mode [Normal]
HD Audio Azalia Device [Auto]
Front Panel support Type [HD Audio]
Onboard Lan [Enable]
Onboard Lan Boot Rom [Disabled]
Marvell 6111 SATA Controller [Enable]
Marvell 6121 SATA Controller [Enable]
Marvell Option ROM [Enable]
Marvell IDE/RAID function [RAID]
Primary Display Adapter [PCI-E]
Allows BIOS to select
Serial Port1 Base
Addresses.
BIOS SETUP UTILITY
Advanced
3. Press to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.