Asus DELUXE SERIES M3A32-MVP - Manual (Page 57)

ASUS M3A32-MVP Deluxe Series 2-31
4. Marvell ® 6121 Serial ATA RAID connector (7-pin SATA_RAID1/2)
This connector is for a Serial ATA signal cable that supports a Serial ATA hard
disk drive. To configure RAID 0 or RAID 1, install two internal Serial ATA hard
disk drives to the SATA_RAID1/2 connectors.
The Marvell IDE/RAID function item in BIOS is set to [IDE] by default. Setting
this item to [RAID] allows you to use the connectors to build a RAID set. See
section 4.4.5 Onboard Devices Configuration for details.
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the Marvell RAID BIOS Configuration utility
and SATA BIOS setup during POST.
M3A32-MVP
DELUXE
®
M3A32-MVP DELUXE
SATA RAID connectors
GND RS
AT
A_TXP1
RS
AT
A_TXN1
GND RS
AT
A_RXP1
RS
AT
A_RXN1
GND GND RS
AT
A_TXP2
RS
AT
A_TXN2
GND RS
AT
A_RXP2
RS
AT
A_RXN2
GND
SATA_RAID1 SATA_RAID2