Samsung SGH-I627MAAATT - Manual (Page 23)

20
Note: If you changed the Language or Locale option, press the Done soft key.
Then you need to turn the device off and then back on for your
changes to take effect.
Date and Time settings
The Date and Time setting enables you to set the date, time, and
time zone.
1. On the Home screen, select Start ➔ More ➔ Settings ➔
Date and Time and press the key.
2. Select your Time zone and set the current Date and Time.
3. You can also enable Auto update by moving the Navigation
key to the Left or Right.
4. Press the Done soft key when you are finished.
Note: You can change the time and date format to be displayed in Regional
Settings.
Power Settings
You can conserve battery power by adjusting the time-out
settings for the display and the backlight of the keypad and
display or adjusting the display brightness.
1. On the Home screen, select Start ➔ More ➔ Settings ➔
More... ➔ Power Management and press the key.
2. Select the power settings:
• Main battery: You can check the remaining battery power.
• Backlight time out on battery: You can select the length of time
the display backlight stays on when you do not use the phone.
Choose from Never, 5 seconds, 10 seconds, 20 seconds, 30
seconds, 40 seconds or 1 minute.
• Backlight time out on AC: You can select the length of time the
display backlight stays on while charging. Choose from Never, 1
minute, 2 minutes, 5 minutes, or 10 minutes.
• Display time out: You can select the length of time the display
stays on. During standby, the phone goes to Sleep mode after a
specified period of time, so very little power is being consumed.
Choose from Never, 10 seconds, 20 seconds, 30 seconds, 40
seconds, 1 minute, 2 minutes, or 5 minutes.
• Display brightness: You can adjust the brightness for the display.
Choose from Level 1- Level 5.
• Light sensor: Uses the light levels to adjust the screen’s brightness
and contrast. Choose Off or On.
• Keypad backlight on: You can select when the keypad backlight is
used. Choose from Any time or Custom time. If you selected
Custom time, enter the time in the following fields.
– Start time
– End time
3. Press the Done soft key when you are finished.