Samsung NP-Q1-V000-SEA - Manual (Page 181)

181
Q
The function
A1 is a function that activates the system from Sleep mode when a
signal (such as a ping or magic packet command) arrives over the network (wired
LAN).
Using the Function
 Click Start > Control Panel > Network and Internet > Network and Sharing
Center > Manage Network Connections.
 Right-click on the Local Area Connection and select Properties.
 Click Configure > Power Management tab. Select Allow this device to bring
the computer out of standby, then click OK. Restart the system.
—
If the system is activated from Sleep mode when there is no received signal,
use the system after disabling the function.
—
When turning the power off when is disabled, the LAN LED
may continue to be lit.
—
Connecting a wired LAN while using a wireless LAN may not activate the
function. Set the Wireless LAN to Disable to use the
On LAN> function.
 Click Start > Control Panel > Network and Internet > Network and Sharing
Center > Manage Network Connections.
 Right-click on the Wireless Network Connections and select Disable.
Wired Network (LAN) Related