Apple Mac Performa 640 series - Manual (Page 172)

If your computer is using a VGA driver, and your Air Series software is
version 3.0, you need to make the following change. (These instructions
assume that you have Windows installed in the C:\WINDOWS directory. If
Windows is elsewhere, type the actual Windows location.)
1 Make sure the Air Series Setup disk is not read-only.
2 Place the disk in drive A.
3 Type the following at the DOS prompt:
A:
COPY SETUP.BMP SETUP.OLD
COPY C:\WINDOWS\RIVETS.BMP A:SETUP.BMP
In addition, you will need to know the following information before you
start:
m Your Internet e-mail address.
m A legitimate, assigned IP address for the machine on which you’re
installing the TCP/IP software (for example, 222.111.11.1). For connecting to
the Internet, your service provider will tell you the correct address. For
TCP/IP networking within your company, your network administrator can
provide you with an address.
m If you are on a network with a subnet mask, the IP address for that mask,
for example:
m 255.0.0.0 for client Class A IP addresses (those between 0.0.0.1 and
127.255.255.254)
m 255.255.0.0 for client Class B IP addresses (those between 128.0.0.1 and
191.255.255.254) and
m 255.255.255.0 for client Class C IP addresses (those between 192.0.0.1 and
223.255.255.254)
m If you will connect through a gateway, the IP address for that device.
m The name of your domain name server (for example, server.edu).
Once you have this information, you can proceed.
164 Appendix D